How to hook up trailer brakes wiring diagram, your answer
You should be able to find what you are looking for there. You can find the exact one that you need and information on how to use it at your local hardware store.
Before drilling, make sure you know where the bit will end up once it's through the firewall. There are several types, and all come with complete installation instructions. The whole process can be completed in about 45 minutes.
How do you hook up springs on brakes for a 87 Ford truck?
Store the harness behind the rear bumper on the fuel tank. I used to work there.
A stepped bit would be great to use. Bind the harness with a tie strap in order to avoid damage. A amp fused battery feed wire and auxiliary circuit routes from the cowl-mounted junction block, along the body side rail, to the rear bumper crossmember.
Thanks for the info. And that can't be right because what if I'm stopped and have the turn signal on.
It has a 4 wire connector to my car but one of the wires on the trailer connector was worn out and probably not working. It will save you from figuring out how to hook up trailer lights, because you will have a trailer harness connector already there, in the rear bumper.
After plugging the harness into the exiting plugs, you have to ground the converter, and then run a hot wire with an inline fuse to the battery. The other end of the wire is taped to the wiring near the junction block on the cowl. The harness is inside the frame rail. The harness is simply routed out below the light assemblies under the bumper cover and out near the hitch receiver.
If the question is refering to the wiring harness that comes with a Grand Caravan with the optional towing package. You will need 2 wheel ramps, unless you are super skinny, since you must run a hot wire from the battery to the converter box.