Omc control box cable hook up, add your answer
Ensure lock pin is in fully locked position to prevent loss of control. Have your account info and Slingbox on hand for this step as these may be required for activation.
Measure distance from center point A of remote control to each outboard centerline B and add 40 in. Two cables are required for single outboard installations. Mounting surface must be of sufficient strength to provide rigid installation.
Connect Control Cables to Remote Control 1. Adjust throttle lever friction by turning adjustment knob E clockwise to increase and counterclockwise F to decrease friction.
Binding could cause control to jam. Some outboards require an additional bracket B to attach "S" bracket to outboard. Remote control idle adjustment must also be set at slow idle position.
Do not overtighten screw. If outboard is equipped with steering handle, loosen screw F in speed control grip and slide grip off handle, being careful of spring tension.